Canon SADDLE FINISHER K3 Service Manual page 305

3.3 Maintenance Procedure
3.3.1 Cleaning the Components
Inside the Inserter
a. Separation Belt and Feeding Roller
1) Obtain a single sheet of A4 or LTR copy
paper.
2) Remove the finisher PCB cover.
3) Set SW103 on the finisher controller
PCB as indicated in F04-303-01.
4) Moisten the paper obtained in step 1)
with alcohol.
5) Press SW104 on the finisher controller
PCB.
• The separation assembly starts to op-
erate.
6) Keep the copy paper on the pickup slot
to clean the roller.
The pull-off roller is also oper-
ating. To avoid letting the copy
paper pulled in by the pull-off
roller, hold the paper as shown
in F04-303-02 for A4 and in
F04-303-03 for LTR.
7) After cleaning, press SW104 once
again.
• The separation assembly stops to oper-
ate.
COPYRIGHT© 2001 CANON INC.
CHAPTER 4 MAINTENANCE AND INSPECTION
2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
ON
1 2 3 4 5 6 7 8
F04-303-01
Match the trailing
edge of paper.
Rail
Side guide
F04-303-02
Rail
Match the trailing
edge of paper.
Side guide
F04-303-03
4-5