Canon SADDLE FINISHER K3 Service Manual page 266

CHAPTER 3 MECHANICAL SYSTEMS
2) Put the paper pushing plate [3] and the
pushing plate fixing plate [4] through
the gap into the machine, and place it
temporarily on the pushing plate base.
Check to make sure that the emboss of
the pushing plate fixing plate and the
hole in the pushing plate base are
matched.
3) Butt the pushing plate fixing plate [5]
against the tips of the two screws that
were previously fitted.
4) With three screws, secure the paper
pushing plate and the pushing plate fix-
ing plate in place.
5) Remove the two screws used as refer-
ence (to which the pushing plate fixing
plate was butted).
6) Mount the parts that were removed to
detach the paper pushing plate.
2.7.1-3 Reference
When putting the paper pushing plate in-
side the machine together with the pushing
plate fixing plate, they at times tend to sepa-
rate, making the work difficult. If such is
the case, work as follows:
a. Using Double-Sided Tape
Keep the paper pushing plate and the
pushing plate fixing plate together with
double-sided tape[1] (F03-201-51). Then,
perform the work under 2.1.7-2, starting
with step 2).
3-64
COPYRIGHT© 2001 CANON INC.
[3]
2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
F03-201-48
[5]
F03-201-49
[1]
F03-201-50
[4]