Inserter; Overview; Electrical Circuitry - Canon SADDLE FINISHER K3 Service Manual

CHAPTER 2 OPERATION OVERVIEW

14.2 Electrical circuitry

The inserter is controlled by the finisher controller PCB, so there is no controller board
inside the inserter. The control signals sent from the finisher controller PCB are received by
the inserter driver PCB and drive the motors, clutches and solenoids. When the module ON
signal from the finisher controller PCB comes ON, power is supplied to the inserter loads.
Finisher
controller
PCB
Copier
2-158
COPYRIGHT© 2001 CANON INC.
Serial
communication
Module
isolation signal
Sensor
F02-1402-01
2000 2000 2000 2000
IC841
Q860 Q861
JP1
Crystal

Inserter

driver PCB
CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
Clutches
Solenoids
Sensors
Motors
Sensors
Sensors
LEDs