Canon SADDLE FINISHER K3 Service Manual page 384

3.1.7 E530 (rear aligning plate motor M5)
-
1) Does the rear aligning plate operate in keeping with alignment op-
NO:
YES: Go to step 4.
Finisher controller PCB, Wiring
2) Is the voltage at J104A-6 (+) on the finisher controller PCB 24 V?
NO:
Wiring
3) Check the wiring from J104A-6 to -10 of the finisher controller
NO:
YES: Replace the rear alinging plate motor.
Rear aligning plate home position sensor (PI8), Finisher controller PCB
4) Is the voltage between J104B-6 (+) and J104B-7 (-) on the finisher
YES: Replace the sensor.
NO:
COPYRIGHT© 2001 CANON INC.
eration?
Go to step 2.
Check the supply of 24 VU to the finisher controller PCB. If good,
replace the finisher controller PCB. If not good, correct the power
supply system.
PCB and to the rear alignment plate motor. Is it normal?
Correct the wiring.
controller PCB 5 V?
Replace the finisher controller PCB.
2000 2000 2000 2000
CHAPTER 5 TROUBLESHOOTING
CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
5-77