Canon SADDLE FINISHER K3 Service Manual page 238

CHAPTER 3 MECHANICAL SYSTEMS
4) Slide the stapler holder [6] until the sta-
pler paper stopper [5] butts against the
stack of sheets; then, tighten the screw.
1.7.3-3 Positioning by Stapling
If the index is not clear upon replacement
of the stapler holder and, in addition, the
stapler has moved, perform the following:
1) Disconnect the finisher from the copier.
2) Fix the stapler holder to the base tempo-
rarily. At this time, try to position it
somewhat toward the rear.
3) Move the stapler [1] to the middle of
the rail.
4) Loosen the screws (2 each) of the sta-
pler paper stopper (left, right).
5) While lifting the swing guide, insert a
stack of several sheets [2], and butt it
again the rear edge stopper [3].
6) Perform manual stapling.
7) Check the position of the staple against
the standards.
3-36
COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
[6]
[5]
F03-107-09
[1] [2] [3]
F03-107-10
Direction
of delivery
F03-107-11