Canon SADDLE FINISHER K3 Service Manual page 364

No. Condition
1 Normal
2 Error
3 Jam
4 Tray alarm
5 Stapler alarm
The state (ON or OFF) of LED1 enables a check on the condition of the saddle stitcher assembly.
LED101 on the finisher controller PCB or the copier itself offers more detailed information.
Note 1: For the DIPSW1 on the saddle stitcher controller PCB, bits 1 through 4 must be OFF.
Note 2: A press on SW2 of the saddle stitcher controller PCB in condition 2 through 5 above causes
the display to be in factory mode. To return to the previous mode, press SW2 once again.
COPYRIGHT© 2001 CANON INC.
Repeats being ON for 1 sec
and OFF for 1 sec.
Repeats being ON for 0.1
sec and OFF for 0.1 sec.
Repeats being ON for 0.25
sec and OFF for 0.25 sec.
Repeats being ON for 0.5
sec and OFF for 0.1 sec.
Repeats being ON for 1 sec
and OFF for 0.1 sec.
T05-205-03
2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
CHAPTER 5 TROUBLESHOOTING
LED1 indication
1 sec
0.1 sec
0.25 sec
0.5 sec
0.1 sec
1 sec
1 sec
0.1 sec
0.25 sec
0.1 sec
5-57