Daikin VAM-FA8VE Technical Data Manual page 69

7 Product Specification
7-2 Optional accessories
7-2-8 DCS301B61: Unified ON / OFF control
Put the attached indication sticker on the room name indication plate.
3
In case of serial type
In case of serial type
Indication sticker
Put the sticker aligning the lines of the sticker with those of the plate.
In case of individual type
Indication sticker
Put the sticker on the center of the frame.
Write the room name in the frame of the sticker with a ball point pen or a felt-tip pen (oil-base).
Reinstall the plate as it were, with checking the correct direction.
4
Close the upper part of remote controller.
5
SELECTING CONTROL MODES
The following four patterns of control mode can be set.
Control
Individual
mode
Operation/stop is
controlled by both
unified ON/OFF
Content
controller and remote
controller.
DS2
setting
NOTE:
• indicates the position of switches.
• Set control modes before turning power supply on.
• When used in conjunction with central remote controller, the control modes of the central remote controller has the priority.
DISPLAY OF MALFUNCTION
Flashing of lamps indicates malfunctions. Contact your Daikin dealer.
When turning power supply on, all lamps may light and UNDER HOST COMPUTER INTEGRATED CONTROL lamp may flash and not accept
the operation for about one minute.
These conditions are not malfunctions.
States of lamps
Flashing of operation lamp
Flashing of UNDER HOST COMPUTER INTEGRATED CONTROL lamp
• HRV • VAM-FA8VE
Centralized
After operated by
unified ON/OFF
controller, operation/
stop is freely controlled
by remote controller
until stopped by unified
ON/OFF controller.
• HRV • Heat Reclaim Ventilation
Indication plate
Indication plate
Timer operation possible
by remote controller
When used in conjunction
with schedule timer,
operation/stop is
controlled freely by
remote controller during
the set time but
operation is not available
when schedule timer is
ON.
Contents of malfunctions
Indicates malfunctions in the indoor unit in the group where the operation lamp is
flashing.
Indicates malfunctions in optional controllers for centralized control.
ON/OFF control impossible
by remote controller
Operation/stop is
controlled by unified
ON/OFF controller only.
Indoor units can not be
operated/ stopped by
remote controller.
(HC0191)
3PA53843
1
7
67