Daikin VAM-FA8VE Technical Data Manual page 55

7 Product Specification
7-2 Optional accessories
7-2-7 DCS302C51: Centralized control
ZONE SETTING (Fig. 3)
You can set multiple groups under a single zone to control them
by zone. This equipment is factory set for 64 zones of 1 group per
every zone at the time of shipment.
Press the ZONE SETTING BUTTON,
1
ZONE
and " " is displayed.
SET
00 01 02 03
1
2
3
2
Press the ADVANCE/ BACKWARD BUTTON to move
the display " " to the group of the desired zone. Holding
the button down will quickly move the display.
3
Press the SELECTOR BUTTON to set the above group in
the zone. The display "
00 01 02 03
1
2
3
4
Press the ZONE OPERATION ON/OFF BUTTON to
finalize the zone. This zone becomes finalized, and the next
zone No. is displayed.
00 01 02 03
1
2
3
In the above example, the zone No. 2 is displayed. Then, the
display " " of the lowest group No. that has already been set
lights up.
• HRV • VAM-FA8VE
Zone No. 1 is displayed.Then,
operation monitor display
" " of group No. lights up in
the displayed zone. The display
" " of the lowest group No.
lightsup.
" of the selected group lights up.
Repeat procedures 2 – 3 to
select all desired groups for
the zone.
The example in the left, groups
1-00, 1-02, 1-03 and 2-00 are set
in the zone No. 1.
The zone No. advances one at a
time. The display " " of the
group that has already been set
is lit in the displayed zone. The
display " " of the lowest
group No. lights up again. Set
the other zones as well following
procedures 2 – 4.
• HRV • Heat Reclaim Ventilation
5
Press the ZONE SETTING BUTTON again, to finish
zoning.
The current display goes out, and the normal display appears.
NOTES
To clear all registered zones Display "
both " " and ALL ¡ for about 4 seconds. This will clear all
RESET
registered zones.
• If you have set a group in the wrong zone, reset it in the correct
zone. (The last zone set is judged to be effective .)
• You cannot set the same group in multiple zones.
• When you turn ON the power, the system may display "
approximately one minute and may not respond to operation
until all the liquid crystal display appears.
• Unless operated from within one minute from when the display
of zoning appears, the display will automatically revert back to
the "group" display.
• A single setting will simultaneously determine the same setting
of all the groups in the zone. So, pay attention to the following
points in setting the zone.
1. The control mode must be the same for all groups in the zone.
2. The scheduled operation must be the same for all groups in
the zone, if the operation is controlled by the timer.
3. The cool/heat operation mode must be the same for all groups
in the zone.
4. The preset temperature must be the same for all groups in the
zone.
Note:
Be sure to select the " - - " in executing the operation by
zone, as well as to set the operation mode and the
temperature setting unless the uniform operation is
performed in the above 3 and 4. (See page 114.)
ZONE
" . Then, hold down
SET
" for
88
(HC0162)
1
7
53