Daikin VAM-FA8VE Technical Data Manual page 34

7 Product Specification
1
7-2 Optional accessories
7-2-3 KRP2A51, KRP2A61: Wiring adapter for electrical appendices
7
2. Setting control mode selector sitch (RS1)
Using control mode selector switch (RS1),
select the control mode as described below.
1. When operating with only individual display function
Position
0
2. When operating with constant input from A
Position
Remote
1 controller
rejection
Central
2
priority
Stop by
remote
3
controller
acceptable
Remote
controller
4
acceptance/
rejection
Note:
• Input B is for forced-OFF. When ON, stop + remote controller is rejected, and input A is ignored. When OFF, even if A is ON, the contents
of when input A is ON are not achieved. Input A must therefore be re-input.
3. When operating with momentary input from A
(Use a momentary input of ON time 200 mili-sec or longer.)
Position Function
Remote
5 controller
rejected
Last
6 command
priority
• For demand control from input B
32
• HRV • VAM-FA8VE
RS1
Factory set:
"0" position
Function
Individual display
(input ignored)
Contents when input A is
Function
ON
Operation (remote
controller is normally
rejected)
Operation + remote
controller accepted
Operation + stop by remote
controller acceptable (No
operation by the remote
controller)
Remote controller
acceptance only (No
operation by the remote
location)
Contents of Input A
Stop for ON while
operating, Operate for ON
while
stopping
Stop for ON while
operating, Operate for ON
while
stopping (Remote
controller is normally
accepted.)
• HRV • Heat Reclaim Ventilation
Contents when
input A is OFF
Stop + remote
controller
rejection
Function of Input B
Input B will be forced
stop function (When
ON, stop + remote
controller is rejected,
input A is ignored.)
(HC0125)