Daikin VAM-FA8VE Technical Data Manual page 56

7 Product Specification
1
7-2 Optional accessories
7-2-7 DCS302C51: Centralized control
7
OPERATION
OPERATION BY ZONE (Fig. 4)
Flow of operation by zone
Call up the desired zone.
Set the control mode.
Set time No.
Set operation mode.
Set temperature.
Start operation.
1
Press the ZONE/GROUP CHANGEOVER BUTTON, to call
upthe display of zoning.
MONITOR
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15
1
2
3
4
2
Press the ADVANCE/ BACKWARD BUTTON, to select
the zone No. Holding it down will quickly move the display.
3
Press the CONTROL MODE BUTTON, to call up the
desired code No. (See page 116.) Following the change, the
display flashes.
Setting is not possible when using a data station or parallel
interface.
54
• HRV • VAM-FA8VE
Stop
The display "
ZONE
of the group set in
the display zone
lights up.
• HRV • Heat Reclaim Ventilation
4
Press the TIMER ON BUTTON.
Press the TIMER ON BUTTON within 10 seconds after the
code No. is displayed. The display stops flashing and lights
up solidly.
CODE
No.
(only in conjunction with the schedule timer)
5
Press the TIME No. BUTTON, to select the desired time
No.. When you change the setting, the display flashes. If you
don't wish to program the to "–".
Check the timer No. of the schedule timer. If the schedule timer
is not programmed, set the program in accordance with the
instruction manual of schedule timer.
6
Press the TIMER ON BUTTON, to finalize the time No.
The display flashes, and then lights up solidly.
Press the TIMER ON BUTTON within 10 seconds after the
time No. is displayed.
"
The display returns to its original state after no less than
10 seconds.
No.
7
Press the OPERATION MODE SELECTOR BUTTON, to
call up the desired mode. If you don't wish to execute the
unified setting in the zone, set it to " - - ". (See page 121 for
further details.)
The display returns
CODE
to its original state
No.
after no less than
10 seconds.
No.
(HC0163)