Daikin VAM-FA8VE Technical Data Manual page 68

7 Product Specification
1
7-2 Optional accessories
7-2-8 DCS301B61: Unified ON / OFF control
7
NAMES AND FUNCTIONS
"UNDER HOST COMPUTER
INTEGRATED CONTROL"
When this lamp turns on, no
other operations are possible.
ROOM NAME
INDICATION PLATE
Refer to the "2. PUTTING
ROOM NAME
INDICATION STICKER"
<< NOTE >>
• When using unified ON/OFF controller with other optional controllers for centralized control, "OPERATION LAMP" of the equipment
which is not operated may turn on or off after several minutes.
This state occurs due to signal communications and is not a failure.
• Do not open the upper part of remote controller except when rewriting the indication sticker or selecting control modes.
PUTTING ROOM NAME INDICATION STICKER
Open the upper part of remote controller.
1
Insert a (–) screwdriver into the recess between
the upper and lower part of remote controller
(at 2 locations) and twist the screwdriver lightly.
PC board is attached both the upper and
lower part of remote controller. Do not
damage the board with the screwdriver.
Pull out the room name indication plate. Insert
2
the point of a mechanical pencil etc, into the
hole of the indication sticker to pull it out.
66
• HRV • VAM-FA8VE
UNIFIED
ON/OFF CONTROLLER
GROUP NO.
00 01
04 05
08 09
12 13
• HRV • Heat Reclaim Ventilation
UNIFIED OPERATION/STOP
BUTTON
Starts/stops all indoor units.
HOST ALL ALL
OPERATION LAMP
02 03
Turns on during operation
of each group and flashes
during malfunction stop.
06 07
INDIVIDUAL
OPERATION/STOP
10 11
Starts/stops each indoor
unit group individually.
14 15
(–) screwdriver
(2 locations)
Indication plate
Control mode selector
(DS2)
(HC0190)