Daikin VAM-FA8VE Technical Data Manual page 212

8.2.1 Name of Parts
(Refer to Figure 1)
8.2.2 Remote Controller and Changeover Switch : Name and Function of Each Switch and Display
2
(Refer to Figure 3 and 4)
8
210
• HRV • VKM-GA(M)V1
Only the items marked with an asterisk (∗ mark) are explanation relating to the functions and display of
the unit. Unmarked items are functions of the combined air conditioners. When using buttons for
functions which are not available (buttons which are not described in the text) will cause "NOT
AVAILABLE" to be displayed.
Contact your dealer for more detailed descriptions of those functions (buttons).
1. ∗On/off button
Press the button and the system will start. Press the button again and the system will stop.
2. ∗Operation lamp (red)
The lamp lights up during operation or blinks if a malfunction occurs.
3. ∗Display "
" (changeover under control)
May be displayed when combined with a VRV-system air conditioner.
It is impossible to changeover heat/cool with the remote controller when this icon is displayed.
4. Display " " (air flow flap)
This displays the direction and mode of the air flow flap of the combined air conditioner.
5. Display " " (ventilation/air cleaning)
This display shows that the total heat exchange and the air cleaning unit are in operation.
(these are optional accessories)
6. Display " " (set temperature)
C
This displays the set temperature of the combined air conditioner.
It is not displayed when the unit is used as an independent system.
7. Display " " " " "
COOLING, HEATING")
This displays the operating status of the combined air conditioner.
•
There is no "heating" for the VRV III system (Cooling only type).
•
" " is only available for systems operating in cooling and heating at the same time.
8. ∗Display "
" (programmed time)
This display shows the programmed time of the system start or stop.
9. Display " " (inspection/test operation)
TEST
When the inspection/test operation button is pressed, the display shows the mode in which the system
actually is.
•
Do not use under usual use (service person/installer only).
10. Display " " (under centralized control)
When this display shows, the system is under centralized control. (This is not a standard specification.)
11. ∗Display "
" (fan speed)
This display shows the fan speed you have selected.
∗ This is only displayed when the fan speed selection button is pressed. It normally displays the set fan
strength of the combined air conditioner.
12. ∗Display "
" (time to clean air filter)
Refer to "8.4.1 How to clean the Air Filter".
13. ∗Display "
" (defrost/hot start)
It may be displayed when freezing of outdoor unit's coil increases in heating mode.
14. ∗Timer mode start/stop button
Refer to the chapter "Operation procedure - Programming start and stop of the system with timer."
(Refer to 8.3.3)
15. ∗Timer on/off button
Refer to the chapter "Operation procedure - Programming start and stop of the system with timer."
(Refer to 8.3.3)
16. ∗Inspection/test operation button
Pressed during inspection or "test run."
•
Do not use under usual use. (service person/installer only)
17. ∗Programming time button
Use this button for programming start and/or stop time.
• HRV • Heat Reclaim Ventilation
" " " " " (operation mode: "FAN, DRY, AUTOMATIC,