Daikin VAM-FA8VE Technical Data Manual page 219

• HRV • VKM-GA(M)V1
HOW TO DESIGNATE THE MASTER REMOTE CONTROLLER
1
2
3
Details and activity of operation
•
Setting the master remote controller (without the "
make slave remote controllers (with the "
remote controller.
Selection of fan mode is possible, however.
•
Setting the master remote controller (without the "
remote controllers (with the "
8.3.3 Programming Start and Stop of the System with Timer
How to Program and Set the Timer with the Remote Controller "BRC1A62" (Refer to Figure 7)
•
The timer is operated in the following two ways.
Programming the stop time "
Programming the start time "
•
The start and the stop time can be simultaneously programmed.
1
2
•
The timer can be programmed for a maximum of 72 hours.
•
Each time when "
Each time when "
• HRV • Heat Reclaim Ventilation
Press the operation mode selector button of the current
master remote controller for 4 seconds.
The display showing"
controll) of all slave remote controllers connected to the
same outdoor unit or BS unit flashes on.
•
" " flashes when the power is first turned on.
•
The ventilation mode can be changed regardless of the
setting (main or slave).
Note
•
This unit cannot control room temperature. If the unit is
connected to the same system with other indoor units, set
the master remote controller on the other indoor units.
Press the operation mode selector button of the controller that you wish to designate as the master
remote controller. Then designation is completed. This remote controller is designated as the
master remote controller and the display showing "
vanishes.
The displays of other remote controller show "
Press the operation mode selector button on the master remote controller (i.e. a remote controller
which does not display "
" " – " " (only for simultaneous cooling/heating systems) – "
The display on slave remote controllers will also change automatically.
Press the timer mode start/stop button "
•
For setting the timer stop "
•
For setting the timer start "
Each time the button is pushed, the indication changes as shown below.
"
Press the programming time button and set the time for stopping or starting the system.
Each time this button is pressed, the time advances or goes backward by 1 hour.
" is pushed, the time advances one hour.
" is pushed, the time goes back one hour.
" (changeover under
" (changeover under control)
" (changeover under control).
") to scroll through the modes.The display will scroll through
" display) to cooling/heating mode will
" display) to follow to the mode of the master
" display) to fan mode will make slave
" display) any setting other than fan mode impossible.
". The system stops operating after the set time has elapsed.
". The system starts operating after the set time has elapsed.
" several times and select the mode on the display.
"
"
"No indication"
"
" – " ".
" "
2
8
217