Daikin VAM-FA8VE Technical Data Manual page 220

2
8
How to Program and Set the Timer with the Remote Controller "BRC1D527" (Refer to Figure 7)
218
• HRV • VKM-GA(M)V1
Press the timer on/off button.
3
The timer setting procedure ends. The display "
to constant light.
•
After the timer is programmed, the display shows the remaining time.
For cancelling the timer operation, push the timer on/off button "
The indication disappears.
Note
•
When setting the timer off and on at the same time, repeat the above procedure (from "
" ") once again.
3
DETAIL EXPLANATION
When you want to stop operation after a desired time,
Example :
Set the time to "8".
↓
8hr
" " will display.
Stops operation 8 hours after the reservation is complete.
The program will be cleared after the operation stops.
•
Set the stop time during operation.
When you want to start operation after a desired time has elapsed
Example :
Set the time to "8".
↓
8hr
" " will display.
Starts operation 8 hours after the reservation is complete.
The reservation is cancelled after operation starts.
•
Set the start time while the unit is stopped.
•
The remaining time will count at the same time after reservation is complete.
See the example below if you want to reserve "off after time" and "on after time" at the same time.
For example : (Refer to Fig. below)
When the timer is programmed to stop the system after 3 hours and start the system after 4 hours, the
system will stop after 3 hours and start 1 hour later.
Example :
•
Setting "off after 3 hours" and "on after 4 hours" will
↓
•
Operation will stop after 3 hours.
Operation will then start in 1 hour from the time it stopped.
•
The controller is equipped with a schedule timer that enables the user to operate the installation
automatically; setting the clock and day of the week is required to be able to use the schedule timer.
•
To set up clock, refer to the operation manual of the remote controller.
Browse to Monday by pressing the "
1
The " " icon appears, "
" " icons might be displayed but all other fields remain blank, indicating that no
actions are programmed for Monday.
Enter the program mode by holding down the "
2
too.
Press the " " button to activate the first programmed action.
3
A blinking " " is displayed indicating that the first programmed action for Monday is being
programmed; The set temperature and clock display are blinking.
Enter the time when the action must start using the "
3
minutes).
• HRV • Heat Reclaim Ventilation
" or "
" button.
" will blink and one of the "
" button for 5 seconds, the "
" changes from flashing light
" once again.
1
" icons, one of the
" icon will now blink
" & " " buttons (min. step = 10
" to