Daikin VAM-FA8VE Technical Data Manual page 62

7 Product Specification
1
7-2 Optional accessories
7-2-7 DCS302C51: Centralized control
7
TEMPERATURE SETTING
(Fig. 6)
1
Press the TEMPERATURE SETTING BUTTON.
Each time you press the "
Each time you press the "
If you don't wish to set the temperature in a unified manner in
the zone, set the temperature to " – – ".
NOTES:
• The setting temperature refers to that of the temperature
sensing part. (It may differ from the room temperature.)
• The proper setting temperature is 26 – 28 C during cooling
operation, and 18 – 23 C during heating operation.
• The setting temperature is not displayed in the FAN mode and
Ventilation/Cleaning mode. The set temperature is not displayed
either if HRV etc. form a zone without an air conditioner.
If you wish to set the temperature to "– –"
C
lower than the lower limit of the range subject to setting,
respectively.
60
• HRV • VAM-FA8VE
", the temperature rises by 1 C.
", the temperature falls by 1 C.
(Example)
In case where the range of
temperature to be set is – 32 C
Press the " " when the display
shows 16 C. The display " – – "
appears.
Press the " " when the display
shows 32 C. The display " – – "
appears.
Set the temperature at the point 1 C
higher than the upper limit and 1 C
• HRV • Heat Reclaim Ventilation
GROUP MONITORING
(Fig. 7)
Utilize the group monitor function in each of the
following cases:
1. Check the malfunction code. (See the next page.)
2. Check the group that requires cleaning of the air
filter and air cleaner element. (See page 125.)
3. Change the setting of the master remote
controller. (See page 124.)
4. Check the group(s) sharing the same outdoor unit.
Or, check the particular group(s) with the master
remote controller setting. (See page 125.)
5. Check the conditions of other individual groups.
1
Press the ZONE/GROUP CHANGEOVER BUTTON on the
display of zoning, and the display "group" appears.
Unless operated from within one minute from when the display
of zoning appears, the display will automatically revert back to
the "group" display.
2
Press the ADVANCE/BACKWARD BUTTON to set the
group No. Then, operation monitor display "
No. lights up in the displayed zone; then, the state of the
above group(s) is displayed in the liquid crystal display.
" of group
(HC0169)