Daikin VAM-FA8VE Technical Data Manual page 112

8 Operation
1
8-1 Method of operation
8-1-2 Operating the HRV unit using the remote control of the VRV- system air conditioner
8
When the VRV-system air conditioner is connected with the HRV unit with a direct duct, the remote control of the air conditioner cannot be
used to select the VENTILATION mode. To use the HRV unit without operating the air conditioner, set the air conditioner in the FAN
VENTILATION mode and select the low fan speed.
Operation lamp
1
Operation / stop button
2
Operation mode display
3
Operation mode selector
4
a
UNIT No.
b
GROUP
c
4
3
1
7
Remote control for indoor unit
8-1-3 Independent operation of the HRV unit
using the Centralized control (DCS302B61)
• After selecting the zone where the only the HRV unit operation
is desired, press the operation mode selector and select "
VENTILATION. The HRV unit can then be operated
independently from the air conditioner.
• When the "FILTER" indication appears on the display, clean
the filter of the HRV unit.(Refer to the section 3.)
110
• HRV • VAM-FA8VE
d
SETTING
e
6 5 2
• HRV • Heat Reclaim Ventilation
• Every time the operation mode selector is pressed, the operation
mode display changes as shown below.
example
When air conditioner and HRV
unit are not connected by duct
• When the
(HC0099)
the filter of the HRV unit. (Refer to the section 3.)
"
When air conditioner and HRV
unit are connected by duct
/ Cooling Ventilation
/ Fan Ventilation
/ Ventilation
"FILTER" indication appears on the display, clean
/ Cooling Ventilation
/ Fan Ventilation
(HC0100)