Daikin VAM-FA8VE Technical Data Manual page 61

7 Product Specification
7-2 Optional accessories
7-2-7 DCS302C51: Centralized control
SETTING OPERATION MODE
(Fig. 5)
• The Zone consists of the following two cases.
A. Zone without display "
The group with master remote controller setting
exists in this zone.
Setting the master remote controller enables cool/
heat selection.
Operations other than cool/heat operations can also
be set for some operations. For further details, see the
list on the right.
B. Zone with display "
No group with master remote controller setting exists
in this zone.
The cool/heat selection is not available because the
master remote controller has not been set.
Some operations other than cool/heat operations can
be set. For further details, see the list in the right.
See page 121 if the display "
1
Press the OPERATION MODE SELECTOR BUTTON. Each
time you press this button, the display rotates as shown on
the right list.
NOTES:
• During cool/heat operation, this central remote controller
enables FAN operation for each zone even without setting the
master remote controller. Meanwhile, ventilation, ventilation/
cleaning, etc. are available, if HRV etc. are connected with this
unit in the zone. See the operation manual provided with the
each unit.
• When the indoor unit is in heat operation, change the setting to
FAN operation through the central remote controller; then, you
can switch the fan speed to the extremely low fan speed. Warm
air may blow if any other indoor unit belonging to the same
system is in heat operation.
• The indoor fan stops during defrost/hot start.
• DRY cannot be set from the central remote controller.
• HRV • VAM-FA8VE
"
"
" is flashing.
• HRV • Heat Reclaim Ventilation
• List of setting operation
A: Zones not displayed
Display Setting
To be set by zone
To be set by zone
1
To be set by zone
To be set by zone
To be set by zone
1
To be set by zone
1
Select this display if you don't
— —
wish to set by zone.
B: Zones not displayed
Display Setting
2
To be set by zone
To be set by zone
1
1
Select this display if you don't
— —
wish to set by zone.
Note:
In the above list, " " refers to the acceptable setting,
while " × " refers to the not acceptable setting.
In the meanwhile, 1 and
1: Setting may not be acceptable depending on the type
of indoor unit with which this unit is connected.
2: The group on FAN operation in the zone performs the
temperature control operation (cool/heat) under the outdoor
refrigerant system.
Contents of setting
Contents of setting
2 refer to the followings.
(HC0163)
1
7
59