Nortel BCM50 Configuration Manual page 21

Global telephony settings
Table 1 Feature settings (Continued)
Attribute Value
Delayed Ring Transfer Off
After 1 ring
After 2 rings
After 3 rings
After 4 rings
After 6 rings
After 10 rings
Park mode Lowest
Cycle
Maximum CLI per line 30 (read-only)
Answer keys Basic
Enhanced
Extended
Receiver volume Use sys volume
Use set volume
Directed pickup <checkbox>
Description
Defines whether unanswered external calls are automatically
forwarded to a prime telephone after this timer expires.
You must assign a prime telephone for this feature to operate. Refer
to "Properties" in the BCM50 Networking Configuration
Allows you to determine how the system assigns a retrieval code to
parked calls.
Lowest, the system chooses the lowest code that is available when
the call is parked.
Cycle, the system will choose the codes in a sequence, from lowest
to highest, until all the codes have been used, then start at the lowest
code again.
Also refer to "Common dialing plan settings" in the BCM50
Networking Configuration Guide
"Timers" on page 23 (Park timeout).
This setting indicates the maximum number of telephones that will
display CLID simultaneously for an incoming call.
The Answer key setting allows you to determine what types of calls
alert at a telephone that has answer DNs assigned. Answer key
changes do not apply to portables.
Warning: Do not change the default setting (Basic) if you have Call
Center active on your system.
Refer to "Answer DN answer key levels" on page 22
each setting.
Also refer to "Line Access - Answer DNs tab" on page
Allows you to specify if the volume level of a receiver or headset
returns to the system default level when a call ends or is put on hold,
or if it remains at the volume level set at the individual telephone.
If selected, allows anyone to answer any calls by specifying the
internal number (DN), where the call is ringing.
Directed pickup is useful when not all the telephones have the same
lines, but you want to allow co-workers to answer a call on any
external line.
Note: Do not confuse Directed pickup with the Group pickup feature.
Group pickup allows you to answer a call at any telephone within a
specific group without specifying the internal number (DN) of the
ringing telephone.
Section 1: System telephony
Guide.
(Call Park access code) and
for attributes of
99.
BCM50 Device Configuration Guide
21