Nortel BCM50 Configuration Manual page 200

200
Section 3: Features
Display prompt
Key: NNN = DNs#; SSS = second DN#; XXX = line number; YYY = second line number
No number stored
No voice call
Not available
Not HG member
Observe
Not in service
Not in service
CANCL RETRY
Not in service
CALLBCK
Not in Service
Observe
Not Supported
Observe
Observe:
RETRY
OK
On another call
LATER
On another call
PRIORITY LATER
N0027146 [Publish Date]
Description of error or action
Speed dial: There is no number stored on the speed dial code you have
dialed.
Message: There has been no number programmed for the message center.
Contact your voice messaging service provider.
Voice call: The telephone receiving the call cannot accept voice calls for one
of the following reasons:
– the telephone is active or ringing with another call
– Call Forward is on
– Do Not Disturb is on
– Voice Call Deny is on
– it is not a BCM50 telephone
– Your call continues as a normal ringing call.
You tried to use a feature that is currently not available from your system.
Transfer: The telephone where you directed a call is not in service or is or
unavailable. The call returns to your telephone.
Silent monitor: The DN you entered is not a Hunt Group member. Press
Observe to enter another hunt group telephone.
Call forward: Two or more telephones are linked in a forwarding chain, and
one is out of service or used for programming.
Transfer: The telephone to which you are trying to transfer a call is out of
service.
Camp-on: The telephone to which you have camped a call is out of service
or is used for programming. The call has come back to you. Press CALLBCK
or the line button to reconnect to the call. On 7000 and 7100 digital phones,
just pick up the handset to reconnect with the call.
Silent monitor: The DN you entered did not respond to the system. Press
Observe to enter another hunt group telephone.
Silent monitor: The DN you entered belongs to a portable telephone or an
ISDN terminal. Press Observe to enter another hunt group telephone.
Silent monitor: The supervisor, hunt group member and the caller are all
connected.
If you make a mistake entering a DN number, press RETRY and re-enter the
number. If the number you entered is correct, press OK.
The telephone you have called is on another call. Press LATER to use the
Ring Again or Message features.
Priority call: The telephone you want to transfer to is on another call.
Display prompts and messages