Ringing Groups - Nortel BCM50 Configuration Manual

Using telephones for special features
Table 1 Hunt group feature operation (Continued)
Feature
Page Zones
Voice Call

Ringing groups

If you set up call scheduling on the system, you can define groups of telephones into ring groups,
which allows you to specify schedules where Trunk Answer can be used within the ring group to
answer incoming calls, even on telephones which do not have that line specifically assigned. You
can also define a second direct dial set for a ringing group.
For details about setting up ringing groups, refer to
For using information about using schedules, refer to
Setting up Call Center
Call Center is run from a separate client. Refer to the Call Center documentation for information
about setting up this feature.
Description
You cannot include Hunt group DNs in a Page zone.
Hunt groups cannot accept voice calls. Answer buttons have no
appearances for voice calls, and the set does not ring.
"Creating ring groups" on page
"Using the control telephone" on page
BCM50 Device Configuration Guide
189
Section 3: Features
43.
182.