7316 Digital Phone Button Defaults - Nortel BCM50 Configuration Manual

Default memory button programming for telephones

7316 digital phone button defaults

Button mapping for the 7316 digital phone is unique. Although the button programming follows
the 7310 digital phone button mapping, the 7316 does not have a second level on its upper button
group. Because of this, the numbering for the 7316 is not consecutive. As well, the top three
buttons on each column of the bottom button group refer to the 7310 upper button programming.
This means that line assignment starts on the fourth button down on the left column, rather than on
the top button, as it does with all other 7XXX digital phones. Refer to the diagrams below.
Internal autodial numbers are assigned to buttons 11, 13, 15, 17, 19, and 21 on the main button
group. Programmed external line buttons descend down the lower left buttons, starting with
button 01. When more than five external lines are programmed, assignment continues on the
lower right buttons, starting at button 06.
The 7316E telephone buttons are mapped differently than the 7316 telephone.
Note:
Therefore, if you replace a 7316 telephone with a 7316E telephone, the button
programming will revert to the default settings for the 7316E.
Figure 37 shows the default button number assignments on the 7316 telephone.
Figure 2 7316 digital phone upper button defaults
7316 upper buttons (PBX and DID) default button settings
Autodial to 227
Autodial to 228
Autodial to 229
Autodial to 230
Btn #
23
25
27
29
Btn #
31 Autodial to 231
33 Autodial to 232
24 Autodial to 239
26 Autodial to 240
BCM50 Device Configuration Guide
143
Section 2: DN records