Table 20 Embark Validation Error Messages - Nortel BCM50 Configuration Manual

Configuring telephones: Digital telephones
Warning: Be careful about redirection loops. For example, if you redirect your lines to
your branch office and your branch office redirects its lines to you, you can create a
redirection loop. If these calls are long distance, significant toll charges may result.
You can redirect only lines that appear at line buttons on your telephone. Since 7000 and 7100
digital do not have line buttons, you cannot use this feature on those telephones. Also, you cannot
use the feature on any telephone connected to an ATA2 or ASM/GASM (analog station modules).
You can answer the telephone if it rings while you are programming Line Redirection, however,
none of the call handling features are available until the feature times out. If you need to use a
feature to process the call, quit Line Redirection programming by pressing FEATURE. Do not
press RELEASE or you disconnect the call you are trying to redirect.
In some conditions, callers can experience lower volume levels when you redirect calls to an
external location.
DPNSS notes
(UK only)
DPNSS lines connected to an Embark switch perform call redirection using the Call Forward
feature to create a tandem link back to the switch.
Before you program Call Forwarding on lines on an Embark switch line, ensure that:
• The DTM is configured to DPNSS and the Host Node switch connection is set to Embark.
• Both real channels and virtual channels are provisioned.
• Routing code or line pool code are programmed for the DPNSS to Embark link.
• Allow redirect must be set to Y (Yes). This field is also located under Capabilities.
During telephone programming for Call Forward No Answer and Call Forward on Busy, when
you enter the Forward to: digits, the system does a validation check with the switch on the
number. If the validation does not succeed, the system displays one of the messages shown in
Table 20.
Table 1 Embark validation error messages
Message
The number is invalid or the destination has
been rejected.
There are no free virtual channels available
for validation.
Destination may be out of service, no
response received.
Description
The destination telephone had DND programmed, or it was in
a programming session.
You either did not set up enough channels or there were no
more available.
The system could not connect to the remote system.
BCM50 Device Configuration Guide
81
Section 2: DN records