Nortel BCM50 Configuration Manual page 103

DN records parameters
Table 7 Capabilities and Preferences - Capabilities panel fields (Continued)
Attribute Values
Page zone Page zone
(1 to 6)
None
Direct dial Set 1 to Set 5
None
Intrustion Protection None
Level
Low
Med(ium)
This feature has been
High
removed
HF answerback <checkbox>
DND on Busy <checkbox>
Paging <checkbox>
Auto hold for incoming <checkbox>
page
Priority call <checkbox>
Description
Assigns this telephone to a page zone.
A zone is any group of telephones that you want to group together for paging
regardless of their location. You can assign one of six zones to each
telephone.
The maximum number of digital telephones in a page zone is 50.
The maximum number of digital and IP telephones in a page zone is 60.
Defines whether you can call the direct-dial telephone from this telephone
using the direct-dial digit.
Digital Doorphone note: Before you install the doorphone hardware, ensure
this is set to None in the DN record you want to use for the doorphone.
If the break-in feature is allowed on any private network MCDN lines (PRI
SL-1) assigned to the telephone, you need to define the level of intrusion for
each telephone. This determines if the user can use the feature, and to what
degree.
None: feature is turned off, user cannot break in on any calls
Low: user can only break into calls on other telephones with low level
protection
Med: user can break into calls on other telephones with low and
medium-level protection
High: user can break into calls on all other telephones with this feature.
Defines whether you can automatically answer a voice call without lifting the
receiver or pressing the Handsfree button.
Note: The feature is not available to model 7000 and 7100 telephones and
wireless handsets.
Speaker volume: Note that the speaker volume on the telephone returns to
the default volume setting determined by the telephone for each new
handsfree call.
Defines whether an incoming call rings if you are already on another call.
Digital doorphone note: Before you install the doorphone hardware, ensure
this is not selected in the DN record you want to use for the doorphone.
Defines whether you can make paging announcements from this telephone.
Digital Doorphone note: Before you install the doorphone hardware, ensure
this is selected in the DN record you want to use for the doorphone.
Not selected - If the telephone is active when a page comes in, the page will
be put on queue until the user hangs up.
Selected = If the telephone is active when a page comes in, the call is
automatically put on hold and the page proceeds.
Note: 7XXX digital phones:
• Condition: This setting is enabled, active call is on mute when the page
comes in.
• Results after page: the call comes off hold, but is no longer muted.
Defines whether this telephone can interrupt calls or override Do Not Disturb
at another telephone.
Section 2: DN records
BCM50 Device Configuration Guide
103