Ring Again; Other Ways Of Communicating With Internal Users; Leaving A Message - Nortel BCM50 Configuration Manual

Feature configuration: Making calls

Ring Again

Use this code to get the system to notify you when a telephone you want to call is no longer busy
or when a line pool becomes available.
There is no system programming to allow/disallow this feature.
Activate feature: While on the call, enter FEATURE 2.
Cancel feature: Enter FEATURE #2.
Blocking user access
You can block the user from using this feature key by setting the set lock for the telephone to
complete restriction. (Telephony//DN record//restrictions//Set lock)

Other ways of communicating with internal users

If you cannot reach a person, or if you want to reach more than one person, there are other methods
of communication, including:
• "Leaving a message" on page 211
• "Paging" on page 212
• "Making announcements to individuals (Voice Call)" on page 214
• "Create a conference call" on page 215

Leaving a message

The message feature is a standard system feature and has no specific programming. However,
some telephones and remote voice mail systems may require programming to ensure that message
waiting indicators (MWI) perform as expected.
This feature allows you to leave a message on the display of another telephone in your system or to
analog telephones connected to an Analog Station Module (ASM/ASM8+). The Messages feature
indicates if you have any messages waiting.
The Messages feature uses a message waiting list to keep a record of your internal messages and
your (external) voice mail messages. To keep a record of external voice mail messages, you must
have access to BCM50 Voice Messaging service with visual message waiting indication and a
BCM50 digital telephone.
Section 3: Features
BCM50 Device Configuration Guide
211