Dap Controller Deactivation - Avaya CS 1000 Fundamentals

Sip dect fundamentals
Hide thumbs Also See for CS 1000:
Table of Contents

Advertisement

System maintenance
Import a system
Follow this procedure to import a system configuration.
Importing a system configuration
1. Click Start > All programs > DAP controller > DAP Applications > DAP
2. If the system is active, click Activate / Deactivate / System status to deactivate
3. ClickImport System.
4. Browse to the file that contains the system to import.
5. Browse through the configuration tabs, and ensure that all settings are correct.
6. Click Activate / Deactivate / System status to activate the imported system.

DAP Controller deactivation

You can use the DAP Controller to configure the SIP DECT system. In addition, if the DAP
Controller is connected and active, it can perform the following functions:
• Process messaging (Low Rate Messaging and interaction with DECT Messenger).
• Move subscriptions from a nonworking DAP to a working DAP. You can configure the
number of minutes for which a DAP must be unavailable before the system considers it
to be not working; the default is 10 minutes.
• Monitor the SIP DECT system and send archives and alarms by email.
• Provide the built-in DHCP and TFTP servers.
After you configure the SIP DECT system using the DAP Controller, you can perform either of
the following:
• Leave the DAP Controller PC connected and active, so that it performs all the functions
in the preceding list, and you can use it at any time to configure the SIP DECT system.
• Deactivate the DAP Controller software. You can then use the DAP Controller PC for other
purposes, and optionally disconnect it from the network. You can reactivate the DAP
Controller software at any time to configure the SIP DECT system.
166
SIP DECT Fundamentals
Configurator . The IP DECT Configurator window appears.
the system.
Important:
DAP firmware is not added to the archive of the system, so you must click Browse
on the General settings tab, navigate to the folder where the firmware file is
stored, select the file, and click Open.
Comments? infodev@avaya.com
October 2012

Advertisement

Table of Contents
loading

Table of Contents