System configuration
Configuration using IP DECT Configurator
Use the IP DECT Configurator tool to create configuration files for the DAP controller and
DAPs. The IP DECT Configurator is installed and starts automatically when you install the DAP
controller software. You can also start the IP DECT Configurator by using the shortcut to the
IP DECT Configurator tool under the Start menu at Programs > DAP controller > DAP
Applications.
For information about IP DECT Configurator installation, see
page 90.
Perform the following procedures to configure the settings in the IP DECT Configurator.
•
Starting the IP DECT Configurator
•
Adding a new system using the IP DECT Configurator
•
Configuring IP Settings
•
Configuring Network Settings
•
Configuring other settings—Performance/Email Settings
•
Configuring other settings—Customer Information settings
•
Saving the system
•
Enabling or re-enabling the DAPs
Starting the IP DECT Configurator
Select Start > Programs > DAP controller > DAP Applications > DAP
Configurator.
The IP DECT Configurator main window has three panes.
Adding a new system using the IP DECT Configurator
1. In the IP DECT Configurator main window, click New System in the System
2. Enter the System name; for example, System_1.
3. Select SIP on CS1000 SIPL in the PBX menu.
94
SIP DECT Fundamentals
on page 95
on page 102
a. The top pane shows the Settings buttons.
b. The left pane shows the System Control buttons.
c. The middle pane shows the information.
Control settings pane.
The General settings page appears.
Use no special characters in your SIP DECT system name. The folder and the SIP
DECT system share the same name.
Comments? infodev@avaya.com
on page 94
on page 95
on page 103
Installing the DAP Controller
on page 94
on page 100
on page 102
October 2012
on