Table of Contents
Advertisement
Print the hierarchy of the Synchronization structure.
• View
This opens the Location window without asking for a Location file, see Subsection
Synchronization Analyzer Location page
• Load
This button allows you to load a location file to make the DAP positions visible in a map
of the building. When clicking this button, the system asks you to open a Location file (file
that contains a "map" of the building). File type .xml. This location file should have been
created by means of using the Location Builder Tool.
Note:
Using the Location Builder in the DAP Controller Release 5.0 and lower, you can create
maps of the location and import these maps as files in the Sync Analyser. In the DAP
Controller Release 5.2, the Location Builder has been changed completely and is a
tool for third line engineers. It is no longer a tool to be used in the field.
After loading the file, it opens the Location window, see Section Synchronization Analyzer
Location page
• Find
Allows you to search for an RPN based on entering the RPN number, the MAC address
or Info Field.
• Settings
This opens the Settings window. In this window you can set the treshold for RSSI value
and the Threshold for the Phase Difference, in which you can enter the RSSI threshold
and the Phase Difference threshold. This threshold is used to indicate an alarm condition
(displayed in the Visibility information pane in "red". ). In general the default settings are
OK. The Tresholds "max. number of daps seen" and the threshold "min. number of daps
seen" are applicable for the Location viewer. In the Location Viewer, you can select "Show
DAPs seeing the max. nr. of other DAPs" and also "Show DAPs seeing the min. nr. of
SIP DECT Fundamentals
System synchronization analysis
October 2012
155
Advertisement
Table of Contents
