Table of Contents
Advertisement
Install the external housing
3. Remove the foam contents from the cabinet.
4. At the right hand side of the cabinet, you must drill a hole for the cable inlet. Mark
5. Drill a hole for the swivel. Use a 12 mm drill.
218
SIP DECT Fundamentals
Figure 59: Contents of the box
the hole as shown in
Figure 60: Position of the hole in the cabinet
Figure 60: Position of the hole in the cabinet
Figure 61: Drilling the hole (12 mm)
Comments? infodev@avaya.com
on page 218.
October 2012
Advertisement
Table of Contents
