Table of Contents
Advertisement
Install the external housing
11. Close and lock the cabinet.
Installing a C4710E DAP in an external housing with an
external antenna
Install a C4710E DAP in an external housing with an external antenna.
1. Unpack the C4710E DAP.
2. Open the cabinet of the DAP:
3. Drill two holes (10 mm in diameter) in the rear side of the cabinet.
4. Connect the antenna cables to the connectors on the printed circuit board. Secure
230
SIP DECT Fundamentals
• Remove the two screws at the rear side of the cabinet.
• Separate the cover and the rear side from each other.
• The cabinet is held shut by four click parts, two on each long side of the cabinet.
If necessary, use a small screwdriver to carefully open the click parts one at a
time.
the nuts with an SMA Torque Wrench.
Comments? infodev@avaya.com
October 2012
Advertisement
Table of Contents
