Avaya CS 1000 Fundamentals page 108

System configuration
Branch Office configuration supports seamless handover within each branch office, but not
between sites. Support is unavailable for roaming between branch offices.
To configure Branch Office, see
Server 1000 SIP Line Gateway
require information about Branch Office configuration.
Use the following procedure to select a Branch Office configuration.
Selecting a system configuration
1. Perform one of the following steps:
2. Select the SIP DECT system that you are running, and click System
3. Choose Main Site with Branch Office(s) for System configuration, as shown in
108 SIP DECT Fundamentals
Basic (simple) SIP DECT configuration with Communication
on page 93. Use the information in this section when you
If you were referred to this section from
go to step 3.
OR
Open the IP DECT Configurator, and click Modify.
Configuration.
the following figure.
Comments? infodev@avaya.com
Configuring System Settings on page 96,
October 2012