Avaya CS 1000 Fundamentals page 90

Software requirements
DAP configuration without DHCP or TFTP servers
You can perform DAP configuration without DHCP or TFTP servers using the Network Settings
window of the IP DECT Configurator.
Configure a DAP to store IP address and configuration data.
Storing IP address and configuration data on a DAP
1. Start the IP DECT Configurator and select Modify the system.
2. Select the system to modify.
3. In the Network settings pane select the Boot Options tab.
4. Select the DAP Boot Options check box.
5. Select Store configuration into flash memory.
6. Click Apply.
7. Click the Save system button in the left pane.
8. Ensure that the DHCP server is running and that the TFTP server is running.
9. Restart the DAPs.
DAP Controller
Perform the procedures in this section to install the DAP Controller from the CD. You must
execute this procedure only once, and thereafter use the installation for any number of system
configurations. You can change settings later.
Prerequisites
• Install and configure IIS software. For more information, see Internet Information
Services.
• Install and configure DHCP and TFTP servers if you use Microsoft Windows DHCP and
TFTP servers. For more information, see
• Ensure that you have DAP controller or manager software Release 5.2 or later.
• Ensure that you have DAP firmware 4910b524.dwl or later.
• Ensure that you have configured the IP addressing on the network adaptor.
Installing the DAP Controller
1. Insert the CD-ROM in the CD drive, and run setup.exe.
90 SIP DECT Fundamentals
The IP data and configuration data is now stored into the DAPs and the DAPs can
function without the DHCP and TFTP servers.
Comments? infodev@avaya.com
DHCP and TFTP servers on page 76.
October 2012