Table of Contents
Advertisement
Site planning and hardware deployment
Figure 20: Example of a cell center
Use the following procedure to mark the cell boundary.
Demarcating a cell boundary
1. Set up the deployment tool basestation at the cell center.
2. Enter the site survey mode on the handset.
3. See the floor plan and check audio quality in user offices within the cell. If a user
4. Walk into all the areas (rooms) necessary to mark the complete cell boundary. Radio
5. Find the cell boundary by measuring the range and marking it on the floor plan with
50
SIP DECT Fundamentals
In
Figure 20: Example of a cell center
For more information, see
Deployment Kit 2, or
Entering the monitor mode
Deployment tool.
office is in a zone where audio quality deteriorates, relocate the cell center closer
to the critical point or the office.
signals travel further in uncluttered areas than in cluttered areas. Record the cell
boundary.
a small x. Repeat steps
Xs so you can draw a contour arc around the cell center.
For an example of a cell boundary, see
boundary
on page 51.
Comments? infodev@avaya.com
on page 50, IC1 is a cell center.
Entering the site survey mode
3
on page 50 and
4
on page 50 until there you have sufficient
Figure 21: Example of a cell center
on page 43 if you use
on page 213 if you use an older
October 2012
Advertisement
Table of Contents
