Table of Contents
Advertisement
Deployment tool
5. Position the extension arm.
6. Affix the basestation to the extension arm.
7. Position the antenna.
8. Position the basestation. The normal position is with the antenna pointing
9. Mount the battery fixture on the tripod.
10. Mount the battery.
11. Connect the basestation to the battery.
212
SIP DECT Fundamentals
fitting. The thumb screw locking device clicks into the keying hole of the extension
arm.
Orient the arm into the proper position. Secure the tripod fitting and the extension
arm thumb screw.
Remove the basestation from the yellow case. Mount the basestation onto the end
of the arm. Screw the brass thumb screw on the arm into the bottom of the
basestation and secure it in place with the grey lock thumb screw.
Rotate the antenna from the stowed position, against the body of the basestation,
to the upright operating position.
upwards.
Secure the basestation with the arm thumb screw.
Remove the battery bracket, shown in
page 211, from the yellow case. Screw the battery bracket onto the tripod caster
brace by using the two machine screws.
Pull the release pin on the bracket back and slide the battery grooves on to the
bracket. Ensure the bracket pin locks into the battery.
Plug the basestation power cord connector into the upper right edge of the
battery.
Comments? infodev@avaya.com
Figure 56: Deployment tool battery details
on
October 2012
Advertisement
Table of Contents
