Table of Contents
Advertisement
5. After the antennas are put in the vertical position, replace the 4720 DAP cover and
6. Ensure that the antennas are properly locked into the locks in the 4720 DAP cover,
7. Move the antenna cover carefully over the antennas in the vertical position and
8. The 4720 DAP is now ready to install.
SIP DECT Fundamentals
secure the screws at the rear side of the cabinet.
Figure 44: Antennas locked into Cover
as shown in
Figure 45: Antenna in locked position
Figure 45: Antenna in locked position
make sure that the antennas do not bend. When the antenna cover is in place,
attach it by pushing it into its position in the 4720 DAP cabinet.
Figure 46: Cover installed
Adjusting the antenna position
on page 179.
October 2012
179
Advertisement
Table of Contents
