Table of Contents
Advertisement
6. Mount the swivel in the hole that you have drilled. Do not forget to install the rubber
7. Put the foam back into the cabinet.
8. Keep the cabinet in the correct position against the wall and mark the mounting
9. Drill the holes in the wall using an appropriate drill that is applicable for the wall.
10. Mount the cabinet to the wall. Use appropriate screws and plugs.
SIP DECT Fundamentals
ring to seal the conjunction between the swivel and the cabinet. The conjunction
must be waterproof.
Figure 62: Swivel with black rubber ring
Figure 63: Swivel mounted to the cabinet
holes in the corners of the cabinet on the wall. If necessary, use the template that
was delivered with the cabinet.
Figure 64: Marking the corner holes on the wall
Installing 4720 DAP with internal antennas
October 2012
219
Advertisement
Table of Contents
