Avaya CS 1000 Fundamentals page 131

Restart all DAPs
Follow this procedure to restart all the DAPs in a system. This can be required if you are
upgrading software, or if the DAPs are not functioning properly.
Restarting all the DAPs in a system
1. Open Internet Explorer and enter the following URL in the address field: localhost/
2. Click Access points.
3. Click Reboot All.
Deleting a DAP
Follow this procedure to remove a DAP that is damaged beyond repair.
Deleting a DAP
1. Open Internet Explorer and enter the following URL in the address field: localhost/
2. Select Subscriptions from the menu on the left in the DAP manager IP DECT
3. Click Access points.
4. Select the DAP to delete.
5. Click Delete.
SIP DECT Fundamentals
Important:
If you use Reboot to restart a DAP, information about types and software versions
of subscribed handsets is lost, and is restored after several hours. You can
restore this information immediately using either of the following methods:
• Turn the handsets subscribed to the restarted DAP off, and then on again.
• Restart all DAPs using the option "Reboot all" in DAP Manager. For
information, see
cds.
The DAP manager IP DECT page appears.
The DECT Access Points page appears.
cds.
The DAP manager IP DECT page appears.
page.
The Subscriptions page appears.
Restart all DAPs on page 131.
DAP management
October 2012 131