Install the external housing
Installing a C4710 DAP in an external housing
Install a C4710 DAP in an external housing
Installing a C4710 DAP in an external housing
1. Unlock the cabinet, and open the cabinet door.
2. Remove the foam cover and foam blocks from the cabinet.
3. Mount the swivel, and route the incoming cable through the swivel.
4. Verify that the cable fits snugly into the waterproof inlet housing.
5. Connect the incoming cable to the connection box that is delivered with the outdoor
6. Connect the CAT5 cable that is inside the outdoor cabinet to the connector box.
7. Place the foam below the foam blocks.
228
SIP DECT Fundamentals
cabinet.
Comments? infodev@avaya.com
October 2012