Lucent Technologies AP-3 User Manual page 154

APS (Application Plus Server) 4.1 Users Guide
154
Table 12. jtest General Commands (Continued)
Command
dev
sp
san
select
selectinfo
Description
Specifies the logical device number, dev#, of
the Connect7 card for the jtest session. The
syntax of this command is:
dev dev#
If no argument is given, the current dev# is
displayed. This command only takes effect
after issuing the select command.
Specifies the signaling point number, sp#, for
the jtest session. The syntax of this command
is
sp sp#
If no argument is given, the current sp# is
displayed. This command only takes effect
after issuing the select command.
Specifies the service access number for the
jtest session. The syntax of this command is:
san san#
If no argument is given, the current san# is
displayed. This command only takes effect
after using the select command. The service
access number 64 is reserved for the db
(virtual console) session.
Sets the device number, signaling point
number, and service access number for the
current jtest session. Use the select command
after you input those numbers with the dev,
sp, and san commands. This command takes
no argument.
Displays the current selections of device
number, signaling point number and service
access number. This command takes no
argument.
101-1830-001 Issue 1.0