Brake Pedal replacement
Preparations
Remove the Brake Pedal
Install the Brake Pedal
Pedal Release replacement
–
Vivid E80/E90/E95
GC091052 Rev. 3
When preparing for the replacement, you must perform the
following steps:
1. Power down the Ultrasound system.
2. Disconnect the mains power cable from the wall outlet.
3. Disconnect all probes and external I/O cabling.
4. Remove both side covers.
5. Remove the foot rest bumper.
6. Remove the top cover.
7. Remove the front cover.
8. Remove the pedal mechanism.
The pedal is fixed to the pedal mechanism with four (4x) hex key
screws from below. Follow this procedure to remove the brake
pedal:
1. Unscrew and remove the four screws.
2. Remove the brake pedal.
Follow this procedure to install the Brake Pedal:
1. Position the Brake Pedal so you can install the fixing
screws.
2. Install the four fixing screws.
This pedal, placed in the middle, is fixed with three screws.
With this in mind, please refer to 'Brake Pedal replacement' on
page 8-83 for replacement instructions.
Service Manual
Casters and Brakes replacement
8-83