Table of Contents
Advertisement
GE M
S
EDICAL
YSTEMS
D
2392751-100, R
IRECTION
8-6-6
Swivel Release Cable Replacement Procedure
NOTE:
This section describes the installation and removal procedures for the Swivel Release Cable
(Part No. 2392103) only. For instructions on replacing the Gas Spring Cable, refer to the
Cable Removal Procedure
Use the appropriate flat and Phillips-type screw drivers, Allen key, wire cutter and the appropriate
open-wring wrenches as indicated in the swivel release cable replacement procedure.
8-6-6-1
Preparation
Shut down the Vivid™ 4 ultrasound unit, as described in
8-6-6-2
Swivel Release Cable Removal Procedure
1) Raise the control console to its maximum height.
2) Remove the control console lower rear cover, as described in the
Cover Removal Procedure
3) Remove the control console lower cover, as described in the
Removal Procedure
4) Loosen the three screws securing the gas spring cover central sleeve in position (see
below) and lower it downwards until it is resting in the collar of the top cover. (It is not necessary to
remove the sleeve completely).
5) Remove the control console upper cover front, as described in the
(Front) Removal Procedure
6) Remove the keyboard, as described in the
7) Cut all the cable ties to free the swivel release cable.
NOTE:
For clarification, the letters appearing in square brackets [ ] in the following steps correspond to the
letters shown in
8-94
3
EVISION
on page 8 - 89.
on page 8 - 19.
on page 8 - 18.
Figure 8-76 Gas Spring Cover Central Sleeve
on page 8 - 14.
Figure 8-77
and
Figure 8-78
Section 8-6 - Lower Section Components Replacement
Chapter 3 -
Control Console Lower Cover
Keyboard Removal Procedure
below.
V
™ 4 S
IVID
ERVICE
Gas Spring
Installation.
Control Console Lower Rear
Figure 8-76
Control Console Upper Cover
on page 8 - 26.
M
ANUAL
Advertisement
Table of Contents
