Table of Contents
Advertisement
GE M
S
EDICAL
YSTEMS
D
2392751-100, R
IRECTION
7-5-2-1
Service Log In
1) From the System Configuration window, make sure that iLinq (the Common Service platform) is
enabled under the Technical Support tab, as shown in
2) Trackball to OK and press Select. The System Configuration window closes.
Note:
If iLinq was not found to be enabled in
proceeding.
3) Trackball to the wrench icon
Select.
The Profile Manager window is displayed, as shown in
3
EVISION
Figure 7-58 Technical Support - System Configuration
Chapter 7 - Diagnostics/Troubleshooting
Figure 7-58
step
1, it is necessary to re-boot the system before
in the status bar at the bottom of the scanning screen and press
Figure 7-59
V
™ 4 S
M
IVID
ERVICE
below.
on page 7-88.
ANUAL
7-87
Advertisement
Table of Contents
