Table of Contents
Advertisement
GE M
S
EDICAL
YSTEMS
D
2392751-100, R
IRECTION
8-6-10-4
Rear Wheel Installation Procedure
WARNING: Do not lean on the machine, or leave it unattended without support, if a wheel has
been removed.
WARNING: When BOTH rear wheels are being replaced, the machine must be safely supported
on two wooden blocks (or on a jack capable of supporting the weight of the machine). Always
remove and replace one wheel at a time, before attempting to remove the second wheel.
1) Having removed one rear wheel, position the new wheel on the chassis (in the same position as
that of the wheel removed).
2) Tighten the shaft screw (see
3.) If replacing both wheels, when the second rear wheel has been removed, repeat
above to install the second new rear wheel.
4) Return the Vivid™ 4 rear, left and right covers, as described in the
Procedure
8-112
3
EVISION
Shaft Screw
Figure 8-99 Rear Wheel Installation
on page 8 - 7 and the
Section 8-6 - Lower Section Components Replacement
Figure 8-99
below), making sure the wheel is firmly secured.
Side Covers Installation Procedure
V
™ 4 S
M
IVID
ERVICE
step 1
and
Rear Cover Installation
on page 8 - 4.
ANUAL
step 2
Advertisement
Table of Contents
