Frame Grabber Board Replacement Procedure; Tools; Preparation; Frame Grabber Board Removal Procedure - GE Vivid 4 BT03 RFI Service Manual

GE M S
EDICAL YSTEMS
D 2392751-100, R
IRECTION
8-5-9

Frame Grabber Board Replacement Procedure

NOTE: The procedures described in this section are only applicable to Vivid™ 4 systems with the
RFI configuration.
8-5-9-1

Tools

Use the appropriate flat and Phillips-type screw drivers and a wire cutter as indicated in the frame
grabber board replacement procedure.
8-5-9-2

Preparation

Shut down the Vivid™ 4 ultrasound unit, as described in
8-5-9-3

Frame Grabber Board Removal Procedure

1) Remove the Vivid™ 4 left and right side covers, and rear cover - see the
Procedure
2) Disconnect the power cable from the rear of the BEP.
3) Remove the BEP side covers, as described in the
8 - 54.
4) If applicable, remove the octopus card holder as described in the
Removal Procedure
5) Disconnect the frame grabber cable from the rear of the frame grabber board.
Note: Counting from the top, the frame grabber board is positioned in the fifth PCI slot.
6) Release the securing screw located on the left of the board bracket.
7) Gently remove the frame grabber board from the BEP.
8-5-9-4

Frame Grabber Board Installation Procedure

1) Gently insert the frame grabber board into its slot.
Note: Counting from the top, the frame grabber board is positioned in the fifth PCI slot.
2) Fasten the board with the screw on the left of the bracket.
3) Reconnect the frame grabber cable to the rear of the frame grabber board.
4.) If applicable, install the octopus card holder as described in the
Installation Procedure
5) Reconnect the power cable to the rear of the BEP.
6) Install the BEP side covers, as described in the
8 - 54.
7) Return the Vivid™ 4 rear, left and right covers - see the
8 - 4 and
Note: Perform a complete diagnostic check of the system, as described in
Chapter 7 -
8-64
3
EVISION
on page 8 - 7 and the
on page 8 - 56.
on page 8 - 56.
Rear Cover Replacement Procedures
Diagnostics/Troubleshooting.
Section 8-5 - Back End Parts Replacement
Chapter 3 -
Side Covers Installation Procedure
BEP2 - Side Cover Removal Procedure
BEP2 - Side Cover Installation Procedure
Side Covers Installation Procedure
on page 8 - 7.
V ™ 4 S
IVID ERVICE
Installation.
Rear Cover Removal
on page 8 - 4.
BEP2 - Octopus Card Holder
BEP2 - Octopus Card Holder
M
ANUAL
on page
on page
on page