Mitsubishi Vcr Setup Procedure - GE Vivid 4 BT03 RFI Service Manual

GE M S
EDICAL YSTEMS
D 2392751-100, R
IRECTION
8-8-2-4-1

Mitsubishi VCR Setup Procedure

NOTE: This procedure must be performed on initial Mitsubishi VCR installation.
NOTE: The Mitsubishi VCR can be configured using the Menus on the front panel
• Use the Jog button to navigate between the selections.
• Push the Enter button to apply your selection.
To configure the Mitsubishi VCR:
1.) Press the VCR Play B. button on the Vivid™ 3 control console to display the VCR menus on the
Vivid™ 3 monitor.
2.) Using the Jog button on the VCR front panel
language
3.) Select the <Menu1> settings, according to the configuration shown in
press the Enter button to continue to the next menu.
8-122
3
EVISION
Figure 8-110 Mitsubishi VCR Front Panel
(Figure 8-111), then press the Enter button to continue to the next menu.
Figure 8-111 Language Menu
Section 8-8 - Peripherals
(Figure 8-110), select the required VCR menu
V ™ 4 S M
IVID ERVICE ANUAL
(Figure 8-110) as follows:
Jog Button
Enter Button
Figure 8-112 below , then