Table of Contents
Advertisement
GE M
S
EDICAL
YSTEMS
D
2392751-100, R
IRECTION
8-5-11
CDRW Drive Replacement Procedure
8-5-11-1
Tools
Use the appropriate flat and Phillips-type screw drivers and a wire cutter.
When installing a new CDRW Drive on systems that have software versions earlier than 4.1, it is
necessary to install the CD-RW patch (P/N 2413448) that is supplied as part of the CD-RW Kit, as
shown below.
CD-RW Kit part number 2413449 consists of the following items:
8-5-11-2
Preparation
Shut down the Vivid™ 4 ultrasound unit, as described in
8-5-11-3
CDRW Drive Removal Procedure
1) Remove the Vivid™ 4 left and right side covers, and rear cover - see the
Procedure
2) Disconnect the power cable from the rear of the BEP.
3) Remove the BEP left and right side covers, as described in the
Procedure
4) Remove the BEP front cover as described in the
8 - 54.
5) Remove the cables (data and power) that connect to the rear of the CDRW Drive.
6.) Carefully slide the CDRW Drive out from the front of the BEP as shown in
8-66
3
EVISION
ITEM PART NO.
2346017
2413448
2413450-100
on page 8 - 7 and the
on page 8 - 54.
Figure 8-51 CDRW Drive Removal
Section 8-5 - Back End Parts Replacement
DESCRIPTION
CD-RW Drive
CD-RW Patch
CD Patch CD-RW Installation Instructions
Chapter 3 -
Side Covers Installation Procedure
BEP2 - Front Cover Removal Procedure
V
™ 4 S
IVID
ERVICE
Installation.
Rear Cover Removal
on page 8 - 4.
BEP2 - Side Cover Removal
Figure 8-51
below.
M
ANUAL
on page
Advertisement
Table of Contents
