GE Vivid 4 BT03 RFI Service Manual page 86

GE M S
EDICAL YSTEMS
D 2392751-100, R
IRECTION
Table 3-6
b
3
EVISION
Damage Inspection Checklist
Step Item
1
Console
2
Probe Holders
3
Control Panel
4
Probes
5
Monitor
6
Fans
7
BE Rear Panel
8
Covers
9
Peripherals
10
AC System
11
Power Cord
12
Front Castors
13
Rear Castors
Chapter 3 - Installation
Recommended Procedure
Verify that the system is switched OFF and unplugged. Clean the console and
control panel.
Clean the gel wells with warm water and a damp cloth to remove all traces of gel.
Physically inspect the control panel for missing or damaged items. Verify the proper
illumination of all the control panel buttons.
Check all probes for wear and tear on the lens, cable, and connector. Look for bent
or damaged pins on the connector and in the connector socket on the unit. Verify
that the EMI fingers around the probe connector socket housing are intact. Check
the probe locking mechanism and probe switch.
Clean the CRT with a soft cloth dampened with water. Repeat using only water,
and wipe with a dry cloth. Inspect the monitor for scratches and raster burn.
Verify that the FE crate cooling fans, BE fan and peripheral fans are operating and
clean.
Check the BE rear panel connectors for bent pins, loose connections and loose or
missing hardware. Screw all the cable connectors tightly to the connector sockets
on the panel. Verify that the labeling is in good condition.
Check that all screws are in place, all chassis and internal covers are installed and
that the air filters are in place.
Check and clean the peripherals in accordance with the manufacturer's directions.
To prevent EMI or system overheating, dress the peripheral cables inside the
peripheral cover.
Check the AC board connectors and the associated cabling for good connection
and proper insulation. Verify that the connections are secured.
Check the power cord for cuts, loose hardware, tire marks, exposed insulation, or
any deterioration. Verify continuity. Tighten the clamps that secure the power cord
to the unit and the outlet plug to the cord. Replace the power cord and/or clamp, as
required.
Check that the front castors can swivel, and can be placed in swivel lock and full
lock by the foot brake pedal.
Check that the rear castors can roll and swivel but cannot lock.
V ™ 4 S M
IVID ERVICE ANUAL
3-15