Checking The Network Adaptors From Windows Device Manager - GE Vivid 4 BT03 RFI Service Manual

GE M S
EDICAL YSTEMS
D 2392751-100, R
IRECTION
7-4-9

Checking the Network Adaptors from Windows Device Manager

NOTE: This check is performed on the system while in Technical Support Mode, as described below. Make
sure the T-plug (dongle) is inserted into the parallel or USB port on the Vivid™ 4 rear connectors panel.
1) Turn ON the system by pressing the ON/OFF button on the control console and re-boot into
Technical Support Mode using the T-plug.
While re-booting the system, be prepared to select Technical Support Mode when prompted, then
press <Enter>.
2.) From the Windows desktop, select Start > Programs >Computer Management > Device
Manager > Network Adaptors, as shown below.
3.) Make sure that the Intel(R) PRO/100VE Network Connection is indicated as shown in
Figure
7-84
3
EVISION
Figure 7-57 Checking the Network Adaptors
7-57, above.
Section 7-4 - Performing Back End Diagnostics on the System
V ™ 4 S M
IVID ERVICE ANUAL