Table of Contents
Advertisement
GE M
S
EDICAL
YSTEMS
D
2392751-100, R
IRECTION
8-5-15-4
BEP2 Power Supply Installation Procedure
Note:
When performing this procedure, it is recommended to work with the BEP2 lying on its side
(as shown in
NOTE:
For clarification, the letters appearing in square brackets in the following steps correspond to the letters
shown in the illustration of the BEP2 Power Supply and cable connectors in
1.) Route the cable loom down into the cavity of the BEP casing (placing the cable labelled [E] in
8-64
feed the cable connectors underneath the data cables.
2.) Holding the new BEP2 power supply in one hand, connect the 4-pin external connector [A] to the
motherboard (beside the CPU).
3.) Slide the power supply into the BEP power supply location (see
metal stabilizing bracket (located on the side of the power supply) downwards to hold the power
supply in position.
Power Supply Location
Power Cable to Floppy Disk
Power Cable to Hard Disk
3
EVISION
Figure 8-60
on page 8-76), to provide easier access.
H
A
Figure 8-64 BEP2 Power Supply with Cable Loom and Connectors
at the front of the loom) and arrange each of the cables in the approximate position. Carefully
Figure 8-65 BEP2 Power Supply Location
Chapter 8 - Replacement Procedures
G
Not used
I
B
C
V
™ 4 S
IVID
Figure 8-64
Cable Connections
A
Motherboard (beside CPU)
E
B
Motherboard (beside ECG)
C
BEP rear
D
Floppy Disk
E
PC-VIC
F
F
Hard Disk
G
CD-RW
H
MOD
I
ECG
D
Figure 8-65
below) and push the
Ground Cable
PC-VIC
Power Cable to PC-VIC
Data Cable to PC-VIC
M
ERVICE
ANUAL
below.
Figure
8-79
Advertisement
Table of Contents
