GE Vivid 4 BT03 RFI Service Manual page 479

GE M S
EDICAL YSTEMS
D 2392751-100, R
IRECTION
10) Using a combination wrench, release the swivel release cable from the cable retaining bracket by
loosening the securing nut, as shown in
11.)Release the swivel release cable from the up/down handle by carefully sliding the cable end stopper
out through the grooved slot on the handle assembly (refer to the detail shown in
page 8-101).
NOTE: IMPORTANT - Before finally removing the swivel release cable, pay attention to its path inside
the machine, and the position of each of its parts.
12.)Remove the swivel release cable.
8-96
3
EVISION
Figure 8-79 Swivel Release Cable and Retaining Bracket
Figure 8-80 Releasing the Swivel Release Cable Securing Nut
Section 8-6 - Lower Section Components Replacement
Figure 8-74 below.
V ™ 4 S M
IVID ERVICE
Slide bracket in this direction
Cable retaining bracket
Loosen cap screws here
Swivel release cable
Cable retaining bracket
Swivel Release Cable
Figure 8-88
ANUAL
on