Vme Bus (Vme) Diagnostic Tests (For Rft Configuration) - GE Vivid 4 BT03 RFI Service Manual

GE M S
EDICAL YSTEMS
D 2392751-100, R
IRECTION
7-3-4

VME Bus (VME) Diagnostic Tests (for RFT Configuration)

The VME Bus diagnostic test checks the communication on the VME Bus between the IP card, the FEC
and the RFT.
Note: Before performing the VME Bus test, perform the IMP test, as described in the
Diagnostic Tests (for RFT Configuration)
performed without first performing this test, and errors are identified, you must perform the IMP
test to ensure that the VME board is the source of the error.
1) Access the FE Diagnostics dialog box, as described in the
Options
2) In the FE Diagnostics dialog box, trackball to the VME tab and press Select,
OR
Trackball to the VME button in the Data Flow Map and press Select.
The VME tab is displayed, as shown below:
3
EVISION
section, on page 7-6.
Figure 7-8 VME Tab - FE Diagnostics Dialog Box
Chapter 7 - Diagnostics/Troubleshooting
section, on page 7-13. If the VME Bus test is
Accessing the Front End Diagnostic
V ™ 4 S M
IVID ERVICE ANUAL
Image Port (IMP)
Data Flow Map
Test Description Area
Test Area
Comment Area
Tabs
7-15